Downloadable templates
Every template is drawn to the exact size you are ordering, with the bleed, the trim and the safe zone already marked on it — and the crease, if your piece folds. Choose what you are printing and the template follows.
Choose what you are printing
The product, the size, and whether it folds or prints on both sides. The same choices you make when you order.
Check the drawing
You can see the template here before you download it, and how many files your piece needs.
Work on top of it
Open it in whatever you design in and build your artwork over the guides, ideally on a separate layer.
Delete the guides
Take the guide layer out before you send us the artwork, or the lines will be printed along with your design.
Bleed Trim Safe zone Fold
Setting up your artwork
What is bleed?
Bleed is the part of your design that is printed and then trimmed away. Printers cut with a little movement either way, so anything meant to reach the edge of the card has to carry on past it. Every size on this page already includes 3mm of bleed on every edge — design to the edge of the template and the finished piece has no white slivers.
What is the safe zone?
The dashed green line, 5mm inside the trim. Keep anything you need to be read — names, dates, addresses — inside it, so that the same small movement at the guillotine never clips a word.
Why is the inside of a folded card one wide page?
Because that is how it is printed. A folded card is one sheet of paper creased down the middle, so the two inside pages are printed side by side on a single sheet with the fold between them. The template shows the crease so you know where it falls.
Should I send CMYK or RGB?
Either. CMYK gives you more control over how a colour reproduces, so send it if you have it. If your file is RGB that is perfectly fine — our press converts to print colours as it prints. Very vivid greens, oranges and blues can shift slightly.
What resolution do photographs need?
300 DPI at the size it will be printed, or higher. Below about 200 DPI a photograph starts to look soft on paper even though it looked fine on screen. Artwork drawn as vector — type, logos, line work — has no resolution to lose and prints sharp at any size.
What file should I send back?
A PDF is best, with the fonts embedded. We also take JPG, PNG and TIFF. If you work in Illustrator or InDesign you can send those too, though we cannot preview them in your browser — our studio checks them by hand instead.
Do I need to add crop marks?
No. We add the crop marks, the trim box and the bleed box when we build the file for press, so you only need to supply the artwork itself at the size the template gives you.